How to make light up shadow box card.

Hi, crafty friends!

Today I make light up shadow box using Lawn Fawn shadow box card dies.

When you pull the pull tab, the windows glow.

This shadow box can be placed in an envelope when folded.

I'm using these stamps and dies.
"Lawn fawn shadow box card"

"Lawn fawn here we go a-waddling"
"Lawn fawn here we go a-waddling lawn cuts"

"Lawn fawn winter village"
"Lawn fawn winter village lawn cuts"

"Lawn fawn starry backdrops"
"Lawn fawn push here"

What you need to make a light up card is like this.
"Chibitronics Red, Yellow, and Blue LED Sticker Pack"
"3V coin cell battery"（CR1616）
"5mm wide Copper tape"

I will make the parts referring to the picture below.

• Die cut a pattern paper with shadow box die.
• Cut a white cardstock for background.
• Cut a white cardstock for the circuit.
• Cut the white vellum paper for the windows.
• Die cut a white cardstock with hillside border dies.
• Stamp the penguin, house and lantern using Tsukineko Memento Tuxedo Black and coloring with copics.
• Cut out the windows with a craft knife.
• Pull tab parts (0.5 x 2 inch)
• Switch parts (0.5 x 0.5 inch)
• Cut the heat resistant acetate sheet and stamp the sentiment using Versamark, and then heat embossing with silver embossing powder.

Stamp the star background with Versamark and heat embossing with the clear embossing powder.

Coloring with salty ocean and black soot distress oxide inks.

Cut out the windows with a craft knife.

Make a slit for the switch.

• Draw three lines for the slit.
• Draw a line every 1/4 inch from the bottom.
• From 1/4 inch from the right end, draw a 1 inch long line.
• Cut out the 1/32 x 1 inch slit.

Mark the position of the battery and Chibitronics and draw the circuit with a pencil.

Adhere a double-sided tape at the position of the battery.

Adhere the copper tape on the drawing path.

• In the position of the battery, adhere the copper tape on the double-sided tape.
• Place the battery on the copper tape with the positive side up.
• Adhere the positive side copper tape on the battery.
• Adhere the yellow Chibitronics on the mark.

Make the switch part.

• Fold square parts in half.
• Insert the switch part into the slit.
• Adhere the copper tape to the same position as the copper tape attached to the circuit paper.
• Pull out the switch part from the slit and adhere the copper tape around the switch part.

Insert the switch part into the slit again.

Apply a double-sided tape on the switch part and adhere the pull tab part on the switch part.

Adhere the parts on the cover panel and adhere the vellum paper on the back of the windows.

Adhere a thin foam tape around the card base and adhere the cover panel on the card base.

Fold at the score line of the shadow box part.

• Adhere the acetate sheet on the shadow box.
• Make a slit for the pull tab.
• Apply the double-sided tape on the tab.

Through a pull tab on the slit, adhere the card base to the shadow box.

Adhere the hillside border parts on the shadow box.

Adhere the tabs with double-sided tape.

Adhere the penguin parts on the hillside border parts.

I finished it!

When you pull the pull tab, the windows glow.

Be sure to check out the whole video tutorial for more details.

Thank you for stopping by!