How to make light up tiny snow globe tag.

Hi crafty friends!

Today I make light up Halloween tag using Chibitronics and Lawn Fawn stamps and dies.

When you push the sentiment, the snow globe glows.

What you need to make a light up card is like this.
Chibitronics Red, Yellow, Blue MegaPack
5mm wide Copper Tape
CR1216 3V coin cell battery

I'm using these stamps and dies.
Lawn Fawn snow globe gift tag die

Lawn Fawn little sparkle stamp
Lawn Fawn little sparkle die

Lawn Fawn frosty fairy friends stamp
Lawn Fawn frosty fairy friends die

Lawn Fawn say what? Christmas critters stamp

Lawn Fawn stitched hillside borders die

I'm using these papers.
Lawn Fawn mittens remix paper

Lawn Fawn beanie remix paper

Lawn Fawn mermaid cardstock
Lawn Fawn moonstone cardstock
Lawn Fawn white cardstock
Lawn Fawn vellum
Lawn Fawn clear acetate

I'm using this twine.
Lawn Fawn sweetheart single cord

Darice foamies foam sheet 3mm white

Make the parts referring to the picture below.

Die cut the pattern paper, white cardstock and acetate sheet using globe base die.
Die cut the pattern paper and 3mm thick foam sheet using globe frame die.
Die cut vellum using background die.
Die cut moonstone cardstock using snowy background die.
Two top parts, two hillside border parts, two sets of base decorative parts, two globe base parts.
Small battery holder size 1/2 x 1 inch.
Stamp the fairies, wand and mushroom onto white cardstock. Color the parts with Copic markers and die cut using coordinate die.

~Make the circuit~

Put the globe frame, snowy background, and fairies, mark the position of the lights.

Draw the circuit with a pencil.

Fold the battery holder in half and glue it in the center of the globe base.
Mark the position of the Chibitronics.

The outside of the switch is like this.

Stick the copper tape on the pre-drawn path. Place LED stickers on top of the copper tape.

Add battery into the battery holder with positive side up.

Stick short copper tape on the edges of the LED to reinforce.

Cut the switch part of the foam sheet frame.

Stick the foam sheet on the circuit snow globe.

~Create front and back panel~

Make the panels referring to the picture below. Put the top parts, decorative globe base parts and globe base parts on the globe base and globe frame parts.

Put the acetate globe base behind the globe frame.

Glue vellum piece behind the snowy background part.

~Assemble the tag~

Stick the snowy background inside the frame.

Stick the mushroom and one hillside border on the snowy background using glue tape. Stick fairies and another hillside border with thin foam tape.

Stick the front panel on the circuit tag base.

Stick the back panel behind the circuit tag base.

Pass the twine through the tag hole.

Finished! When you push the sentiment, the snow globe glows.

You can make various types of snow globes by changing the inside parts. I present various versions of circuits and supplies below.

~Halloween Version~