How to make light up Christmas ornamental tag.

Hi, crafty friends!

Today I make light up Christmas ornamental tag.

When you pull the pull tab, the ornament glows.

I'm using these dies and stamps.

I'm using green, silver, white cardstock, vellum paper, foam sheet and double-sided tape.

What you need to make a light up card is like this.
"Chibitronics Red, Yellow, Blue MegaPack"
"3V coin cell battery" (CR2016)

I will make the parts referring to the picture below.

Die cut a green cardstock with the ornamental die.
Die cut a green cardstock with the ornamental and the detailed middle strip die.
Die cut a white cardstock with the ornamental die for circuit.
Die cut a silver cardstock with the detailed middle strip die and the top piece die.
Die cut a green foam sheet with the ornamental die and the circle die.
Cut the vellum paper for the windows.
Pull tab parts (0.5 x 2 inch)
Switch parts (0.5 x 0.5 inch)
Silver metallic string.

Red version is here.

Stamp the ornament using versamark and heat embossing with silver embossing powder.

Stamp the sentiment using versamark and heat embossing with silver embossing powder.

Put the cover panel on white cardstock and mark the lights with a pencil.

Mark the position of the pull tab.

Mark the position of the slit and Cut out the 1/32 x 1 inch slit.

Mark the position of the Chibitronics and battery.

Draw the circuit with a pencil.

Adhere the double-sided tape on the position of the battery.

Adhere the copper tape on the drawing path.

Place the battery on the copper tape with the positive side up.

Adhere the positive side copper tape on the battery.

Adhere the red Chibitronics on the mark.

Make a switch part.

Fold square parts in half.
Insert the switch part into the slit.
Adhere the copper tape to the same position as the copper tape attached to the circuit paper.
Pull out the switch part from the slit.
Adhere the copper tape around the switch part.
Make cross-shaped parts like this.

Insert the switch part into the slit again.