Today I make this thank you card.
I used effect sticker on this card, so the LED flashes like pulse in a heartbeat.
The stamps and dies I used are here.
"Dotted patterns Set 1 Creative Dies / SSS"
"Brush Stroke Stripes / SSS"
"Mini Thank You / SSS"
What you need to make a light up card is like this.
"Pink, Orange and Green LED Stickers Pack"
"Circuit Stickers Effects Add-On"
"3V coin cell battery"（CR2025）
"5mm wide Copper tape"
The used cardstocks are here.
"Neenah 80lb smooth solar white card stock"
"Papertreyink Perfect match berry sorbet cardstock"
"Simon Says Stamp black cardstock"
"Darice Foamies® Foam Sheet White 2mm thick"
The used inks and embellishments are here.
"Tsukineko Versamark Emboss Ink Pad"
"Silver Stone Crisp Dye Ink / SSS"
"Heroarts Ultra fine clear embossing powder"
"Frosted Hearts / SSS"
The used inks and markers are here.
"Tsukineko memento tuxedo black"
"Copic sketch markers Y06 RV04 V04 E29"
I will make the parts referring to the picture below.
Upper left：Stamping Brush Stroke Stripes stamp with Silver Stone ink and die cutting with two frame dies.
Upper middle：White cardstock for circuits.
Upper right：Stamping a butterfly stamp with Tsukineko memento tuxedo black ink and coloring with copic markers.
Die cutting a black cardstock with a Thank you die and heat embossing with clear embossing powder.
Lower：Die cutting a 2mm thick foam sheet with two frame dies.
I'm stamping a butterfly stamps with tsukineko memento tuxedo black ink and coloring with copic markers.
Then die cutting with a coordinating die.
I'm die cutting a black cardstock with a Thank you die and adhering on copy paper with temporary adhesive runner.
Then heat embossing with clear embossing powder.
I'm putting a stripe paper on the white cardstock, place a thank you part, a butterfly part and heart embellishments.
I'm marking my lights with a pencil.
Making three holes at the mark.
Making 1/16 inch holes in the card stock and 3/16 inch holes in the foam sheet.
I'm using a small rectangular paper to make switch and drawing the circuit with a pencil.
Place an effect sticker between Chibitronics and the switch.
Connect "-" of Chibitronics to "-" pad of effect sticker and "-" of the switch.
Connect "+" of Chibitronics to signal pad of effect sticker.
Then connect "+" pad of effect sticker to "+" of the switch.
I'm adhering the copper tape on the drawing path.
I'm adhering pink, green and orange Chibitronics LED stickers and a heartbeat effect sticker.
If you press and hold the switch for a while, Chibitronics will flash.
Cutting the switch part of the foam sheet with a craft knife.
Adhering the foam sheet on the card base.
Adhering another foam sheet and stripe cardstock.
Placing a battery in the switch and adhering a stripe cardstock.
Adhering a thank you part, a butterfly part and heart embellishments.
Finally, adhering the cover panel to the card base.
I'm using a Papertreyink Berry Sorbet cardstock.
I finished it!
I'm using a Papertreyink Berry Sorbet cardstock.
I finished it!
Be sure to check out the whole video tutorial for more details.
Thank you for stopping by!
0 コメント:
コメントを投稿